CAUTION
Unit Damage Hazard
Failure to follow this caution may result in equipment damage or improper operation.
Failure to remove shipping tape and screw will prevent fresh air vent door from opening and may result in damage to vent door cable.
3.Carefully remove shipping tape from the front panel and vent door. See Figure 20
Figure 20 |
Shipping Tape Location |
SHIPPING |
TAPE |
FRP020 |
4.Remove shipping screw from the vent door, if present. See Fig 21.
Figure 21
Shipping Screw Location
REMOVE SHIPPING
SCREW IF PRESENT
FRP021
5. Remove front panel. See Figure 22.
Figure 22 |
Removing Front Panel |
2 |
1 |
FRP022 |
Pull out at the bottom to release it from the tabs (1). Then lift up (2).
NOTE: If the unit is mounted flush to the floor, the service cord MUST be rerouted at the bottom of the front cover on the side closest to the receptacle. A notch MUST be made in the front cover side where the cord exits the unit. It is the responsibility of the installer to create an exit notch.
17
