Friedrich 920-087-09 operation manual New Construction Accessories

Accessories

New Construction Accessories

PDXWS	WALL SLEEVE Galvanized zinc coated steel is prepared in an 11-step process,
	then powder coated with a polyester finish and cured in an oven for exceptional
	durability. The wall sleeve is insulated for sound absorption and thermal ef-
	ficiency, 16" High x 42" Wide x 13 3/4" Deep.
PDXWSEXT	DEEP WALL SLEEVE EXTENSION For use when the wall is thicker than 13
	1/4”deep. The wall sleeve may be special ordered through your Sales Represen-
	tative and will be cut to your specific depth requirements..
PXGA	GRILLE Standard, stamped aluminium, anodized to resist chalking and oxidation.
PXAA	ARCHITECTURAL GRILLES Consist of heavy-gauge 6063-T5 aluminum alloy:
PXBG	PXAA – Clear, extruded aluminum
PXSC	PXBG – Beige acrylic enamel
	PXSC – Also available in custom colors.
PXDR10	CONDENSATE DRAIN KIT Attaches to the bottom of the wall sleeve for internal
	draining of condensate or to the rear wall sleeve flange for external draining.
	Recommended on all units to remove excess condensate. Packaged in quantities
	of ten.
PXSB	DECORATIVE SUBBASE Provides unit support for walls less than six inches
	thick. Includes leveling legs, side filler panels and mounting brackets for electri-
	cal accessories. Accepts circuit breaker, power disconnect switch, or conduit kit.
RT6	DIGITAL REMOTE WALL THERMOSTAT Single stage cool, single stage heat
	for PDE models or single stage cool, dual stage heat for PDH model thermostat
	features high/low fan speed switch. Thermostat is hard wired and can be battery
	powered or unit powered. Features backlit display and multiple configuration
	modes. For use on PD-series Friedrich PTACs and Vert-I-Paks.
PDXRT	REMOTE THERMOSTAT ESCUTCHEON KIT This kit contains ten escutcheons
	that can be placed over the factory control buttons when a remote wall mounted
	thermostat is used. The escutcheon directs the guest to the wall thermostat for
	operation and retains the LED window to display error codes and diagnostic
	information.
		FRP029
PXSE	SLEEVE EXTENSION RETROFIT KIT Galvanized zinc coated steel, 2.4" sleeve
	extension attached to the room side of the sleeve to allow for the installation of a
	PD-Series Friedrich PTAC in a T-Series sleeve.
PDXDAA	LATERAL DUCT ADAPTER Attaches to the PTAC/PTHP unit and provides a
	transition to direct up to 35% of the total CFM to a secondary room, either left or
	right of the unit. Kit includes duct plenum with discharge grille and internal baffle,
	adapter and end cap.
PDXDEA	LATERAL DUCT EXTENSION A three-foot insulated plenum that attaches to
	the left or right side of the duct adapter. The extension can be cut to length by the
	installer. Maximum allowable straight extension is 15 feet.

30