How To Connect
IMPORTANT: Please read following electrical safety data carefully.
WARNING
Electrical Shock and/or Unit
Operation and Damage Hazard
Failure to follow this warning could result in personal injury or death and/or unit damage.
Follow the National Electrical Code (NEC) or local codes and ordinances.
For personal safety, this unit MUST BE properly grounded.
Protective devices (fuses or circuit breakers) acceptable for unit installations are specified on the nameplate of each unit.
Do not use an extension cord with this unit.
Aluminum wiring in the building may present special problems - consult a qualified electrician.
When unit is in STOP position, there is still voltage to the electrical controls.
Disconnect power to unit before servicing by:
1.Removing power cord (if it has one) from wall receptacle.
2.Removing branch circuit fuses or turning circuit breakers off at panel.
1.Remove front panel. See Figure 22.
2.Remove junction box.
•Remove junction box cover by removing three screws from front. Remove junction box by taking out top, rear and side screws. See Figure 24.
Figure 25 |
|
|
|
|
|
|
|
Junction Box Location |
| ||||||
|
|
|
|
| High |
|
|
Powe | r |
| Med |
| Heat | UNIT | |
|
|
|
| ||||
|
| Low | od | e | Cool | ||
| n | d | M |
|
|
| |
| Fa | Spee |
|
| Fan | e | CONNECTOR |
|
|
|
|
|
| Temperatur | |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| JUNCTION BOX |
|
|
| JUNCTION BOX COVER | ||||
|
|
|
|
|
|
| FRP017 |
3.Connect accessory power supply cord or hard wire connector to unit connector. See Figure 26.
•Units must be installed using the appropriate power supply kit. See Table 2
Figure 26
Power Connection
|
|
| High |
|
|
|
Powe | r |
| Med | Heat |
| |
|
|
|
| Cool |
|
|
| n | Low |
|
|
|
|
| Speed | Fan |
|
|
| |
| Fa |
|
|
| ||
|
|
| Mode | Temp | eratur | e |
ACCESSORY
POWER SUPPLY CORD
OR HARD WIRE
FRP018
See Table 2 on page 14 for power cord accessory options and ratings.
4.Reinstall junction box and cover.
•Use wire clamp to attach power cord to basepan. Secure with screws (included) See Figure 27.
•Replace junction box and cover with screws removed from
Step 2. Tighten securely.
5.Replace front panel. See Figure 24.
6.Connect power to unit.
Figure 27 |
|
|
|
|
Wire Clamp |
|
|
|
|
|
|
| High |
|
Powe | r | Med |
| Heat |
|
|
| ||
|
|
|
| Cool |
| Low |
|
|
|
| n d |
|
|
|
| Fa Spee | M | Fan |
|
|
| ode | Te | |
|
|
|
| mperature |
|
|
|
| WIRE CLAMP |
|
|
|
| FRP019 |
|
|
|
| 19 |
