STEP 9 – Locate the condensate drain.
The connecting line has a built in condensate line hose that removes the moisture collected from the indoor module. The hose must be located in an appropriate location for drainage. Because the hose relies on gravity to drain, it is important that the hose only points downward for the entire length of the hose.
If the connecting line is rolled to store the excess line as shown in Step 6, the drain line may be removed from the connecting line as shown below and cut to an appropriate length.
STEP 10 – Final Preparation.
Using the supplied connecting line clips (Item #14 in the Accessories List), secure the connecting line to the interior and exterior walls as desired. 5 retaining clips are provided from the factory along with standard #8 x 1 1/2” screws and wall anchors.
For installations with the connecting line going through the wall (option 1) use the supplied filler gasket (Item #7 in the Accessories List) to plug the hole around the connecting line in the wall opening. Additional sealing may be desired or necessary for proper weatherproofing.
Once the connecting line is secure and Steps
Routine Maintenance
Cleaning the unit:
The outer cover of the Breeze indoor module can be cleaned with a damp cloth.
Cleaning the outdoor module can be done by rinsing the module with low pressure water. Refer to friedrich.com for approved coil cleaning agents.
Cleaning the filter:
The indoor module of the Breeze system has a washable filter that should be inspected and cleaned periodically. To access and clean the filter follow these steps.
1.Open the front panel by pulling on the left and right side tabs. The front panel will open upward and lock into the open position.
2.Remove the left and right air filters from the Breeze module.
3.Wash the filters by rinsing with water or by vacuuming the dirt from the filter. Allow the filter to dry completely prior to reinstalling.
4.Reinsert both air filters. Then, lower the front panel and snap the panel into place.
SCORE AND PEEL
STEP 9
Peel away
1.
2.
3.
4.
