Friedrich CP10, CP12 manual Glis

6.The cabinet should be installed with a very slight tilt (about 1/2") downward toward the outside (See Fig. 5). Adjust the bolt and the nut of

Sill Support 6 for balancing the cabinet.

7.Attach the cabinet to the window stool by driving the screws 2 [Type B: Length 16mm (5/8 inch) and below.] through the front angle into window stool. (Fig. 5)

8.Pull each Frame Curtain 5 to each window sash track, and repeat step 2. (Fig. 5)

9.Attach each Frame Curtain 5 to the window sash using screws 3 (Type C). ( Fig. 6)

CAUTION: Do not drill a hole in the bottom pan. The unit is designed to operate with approximately 1/2" of water in bottom of pan.

There is no need to add water if the pan is dry.

10. Slide the unit into the cabinet. ( Fig. 7)

CAUTION: For security purposes, reinstall the 2 screws (Type A) at cabinet's side, that were removed in step 1 on page 12.

11.Cut the Foam-Strip 8 to the proper length (window width) and wedge between the upper window sash and the lower window sash.

( Fig. 8)

Screw(Type B) 2

	1/2"	EN
	About	GLIS
Sill Support 6		H

Sash track

Front Angle

Sill Support 6	Screw(Type B) 2
	Fig. 5

Type C 3

Fig. 6

Power cord Screw(Type A) 1

Screw(Type A) 1

Fig. 7

Foam-Strip 8

Fig. 8

14