Friedrich SH15 operation manual Typical Installation, Notice, Figure O

STEP 3 Slide the cabinet into the hole far enough to allow the guide-channel of the sill plate to contact the inside wall surface (See Figure O).

STEP 4 Drill three (3) 5/32" diameter pilot holes through holes in sill-plate into the framing and install three (3) #12 x 2" long screws (Item #4) (See Figure O).

NOTICE

Instructions for mounting sleeve with slope must be observed to prevent entry of water into room.

Potential property damage can occur if instructions are not followed.

FIGURE O	TYPICAL INSTALLATION
TRIM MOULDING	CAULK ALL SIDES AIR TIGHT
	3/8" (10 MM) SLOPE DOWN
	NOTE: SUPPORT BRACKETS MAY BE OMITTED FROM
SCREW #12A X 2" LONG	THROUGH-THE-WALLINSTALLATIONSIFTHECABINETIS
	SECURED AS FOLLOWS. DRILL 2 HOLES IN EACH SIDE
USE 3
	AND INSTALL 4 FASTENERS (2 EACH SIDE).
	USE #12A X 2" (51 MM) SCREWS, TOGGLE BOLTS OR
	EXPANSION ANCHOR BOLTS AS SHOWN IN STEP 5.

SILL PLATE GUIDE CHANNEL
	SUPPORT BRACKETS (ITEM 1) (SEE NOTE ABOVE)
INSIDE WALL SURFACE	SCREW #12 X 2" LONG, USE ONE IN EACH
	BRACKET. DRILL 5/23 (4 MM) DIA. PILOT HOLES.

NOTE: ALTERNATE FASTENERS WHICH MAY BE USED FOR SECURING THE SILL PLATE IN THE WALL, AND THE SUPPORT BRACKETS TO THE OUTSIDE WALL ARE NOT FURNISHED, BUT ARE AVAILABLE AT A LOCAL HARDWARE STORE.

MOLLY OR TOGGLE BOLT EXPANSION ANCHOR BOLT

STEP 5 Drill two (2) 5/32" (4 mm) dia. pilot holes in each side at the locations shown (Figure O) and install four (4) #12 x 2" screws (Item #4). If the hole construction in Step 2 provides a sturdy mount with solid vertical studs, no support brackets are required. The installation must support the weight of the unit plus an additional weight of 400 pounds (185 kg) on the rear of the cabinet. The support brackets may be used for through-the-wall installations as shown in Figure O, for additional support.

STEP 6 If desired, trim around the cabinet on the room side with a suitable frame molding furnished by the installer (See Figure O).

15