Shell (Cabinet) Preparation
It will be necessary to relocate the sill plate of the cabinet 2" back from its shipping position, and the shell guides 4" forward, to the
IF THIS INSTALLATION IS FOR A SASH WINDOW – With the wide "ange and pilot holes of the sill plate forward, put the screws/nuts in the rear holes of the sill plate and third shell hole from the front (the center of three square holes). Anchor the side angles (Item #6) by engaging the tabs at each end of the sill plate with the bottom loops of the side angle. Engage the tabs at
each end of the top angle (Item #5) with the top loops of the side angle. Install two (2) screws (Item #7) to secure the top angle tabs and the side angle to the
IF THIS INSTALLATION IS THROUGH A WALL – Turn the sill plate end to end so that the wide "ange with pilot holes will be over the wall header (towards the rear) and two inches from the front of the cabinet. Bend the tabs into the channel of the sill plate, put the screws/nuts in the front holes of the sill plate and into the second shell hole from the front. Use one bolt on each side to secure the sill plate to the cabinet. (See Figure C, below.)
FIGURE B |
| 8A X 3/8" LONG SCREW (ITEM #7) | |
|
| 2 REQUIRED |
|
CABINET | TOP ANGLE (ITEM #5) |
|
|
|
| LOOP |
|
| SIDE ANGLE |
|
|
| (ITEM #6) 2 |
|
|
| REQUIRED | Detail | TAB |
|
|
|
LOOP
SILL PLATE
TAB
Detail
FIGURE C | BEFORE | AFTER | ||
|
|
| ||
|
|
|
|
|
| CABINET |
|
| |
|
|
| SCREW | |
|
|
| (2 REQUIRED) | |
SILL PLATE |
| NOTE: HOLES | ||
| MOVED TO | |||
|
|
|
| |
|
|
|
| BACK SIDE |
|
|
|
| NUT |
|
|
| RETAINER, CHASSIS | (2 REQUIRED) |
TURN SILL PLATE | (THIS SIDE ONLY) |
| ||
|
| |||
END TO END | DETAIL 1 |
DETAIL 2
Position the sill plate into the cabinet with the sill plate holes to the back. Align the plate 2 inches from the front of the cabinet and secure it with a nut and bolt in each end.
BEND TABS DOWN
9