Friedrich SH15 operation manual Shell Installation Thick Wall

Shell Installation: Thick Wall

The illustrations below show a standard frame construction installation as well as some suggested ways of adapting the support bracket to thick walls and large brick ledges.

NOTICE

Instructions for mounting sleeve with slope must be obser- ved to prevent entry of water into room.

Failure to follow instructions can result in property damage.

Typical Installation Sill Plate
FIGURE 1	FIGURE 2
10 - 24 SCREW
10 - 24 FLAT NUT		3/8" (10 MM)
3/8" (10 MM)		SLOPE DOWN
SLOPE DOWN
	CUT
	HERE
WOOD
LEDGE		STONE LEDGE
#12A X 2" SHEET METAL SCREW		OUTSIDE WALL
1" X 2" OR 2" X 4" SPACER BETWEEN WALL	DISCARD	CUT TO FIT DIMENSION "A"
		AND BEND DOWN TO FOR A
AND BRACKET SHOULD BE USED ON ALU-	SHADED AREA
		VERTICAL LEG
MINUM, ASBESTOS OR VINYL SIDING
FIGURE 3	FIGURE 4
BRICK LEDGE	STONE LEDGE
3/8" (10 MM)		3/8" (10 MM) SLOPE DOWN
SLOPE DOWN
		STRAIGHTEN TAB TO LAY FLAT ALONG
#12A X 2" SHEET METAL SCREW		THE BOTTOM RAIL OF THE SHELL.
		SECURE THE LONGEST SIDE OF
		THE BRACKET TO THE SHELL.
2" X 4" SPACER		ADJUST IN OR OUT TO
		REST ON THE LEDGE

STEP 4 CUT WINGBOARD PANELS: Measure and cut the wingboard panels from the supplied masonite (Item #8) to !t the spaces between the side window channels and the sides of the cabinet (See Figure F).

NOTE: AFTER CUTTING PANELS, MAKE A TRIAL TEST TO SEE IF THEY FIT THE SPACE WITH ABOUT 1/8" CLEARANCE BEFORE GOING TO STEP 5.

FIGURE F

MEASURE DISTANCE "B" TO THE INSIDE

OF THE CHANNEL ON EACH SIDE

CUT HERE AND DISCARD THE CENTER

WASTE MATERIAL

WINGBOARD

SUBTRACT 1/8" (3 MM) FROM DIMENSION "B" AND MEASURE FROM THE EDGE OF THE WINGBOARD (ITEM

# 8), MARK AND CUT WITH A SAW.

11