Installation Instructions
Models SH15 and SH20
NOTE: THIS MANUAL INCLUDES INSTALLATION INSTRUCTIONS FOR BOTH WINDOW MOUNT AND THROUGH-
WARNING
Explosion Hazard | Electrical Shock Hazard |
Electrically connect unit in accordance with NEC
Code Article 501. Failure to do so can result in
re, or electrical shock.
Electrical Requirements
ALL FIELD WIRING MUST MEET THE REQUIREMENTS OF THE NATIONAL ELECTRICAL CODE (ANSI/NFPA 70) ARTICLE 501.
THE
IMPORTANT: Before you begin the actual installation of your air conditioner, check local electrical codes and the information below.
Your air conditioner must be connected to a power supply with the same A.C. voltage and frequency (hertz) as marked on the data plate located on the chassis. Only alternating current (A.C.), no direct current (D.C.), can be used.
An overloaded circuit will invariably cause malfunction or failure of the air conditioner; therefore, it is extremely important that the electrical power is adequate. Consult your dealer or power company if in doubt.
The following instructions are for HAZARDGARD models and cabinet sizes listed below.
GROUPS |
| CABINET SIZE (H x W x D) | |
|
|
| |
SMALL CHASSIS | SH15 | 15 15/16" x 25 15/16" x 27 3/8" | |
(405 mm x 660 mm x 695 mm) | |||
|
| ||
|
|
| |
MEDIUM CHASSIS SH20 | 17 15/16" x 25 15/16" x 27 3/8" | ||
(455 mm x 660 mm x 695 mm) | |||
|
| ||
|
|
| |
Model Number | Plug Type | Circuit Rating | |
Time Delay Fuse | |||
|
| ||
|
|
| |
SH15 | Junction Box | ||
|
|
| |
SH20 | Junction Box | ||
|
|
|
6
