INSTALLATION
This Use & Care Manual provides specific operating instructions for your model. Use this beverage center only as instructed in this Use & Care Manual. Before starting this beverage center, follow these important first steps.
LOCATION
•Choose a place that is near a grounded electrical outlet. Do Not use an extension cord or an adapter plug.
•If possible, place this beverage center out of direct sunlight and away from the range, dishwasher or other heat sources.
•This beverage center must be installed on a floor that is level and strong enough to support a fully loaded beverage center.
•Consider water supply availability for models equipped with an automatic ice maker.
CAUTION
•Do Not install the beverage center where the temperature will drop below 55°F (13°C) or rise above 110°F (43°C). The compressor will not be able to maintain proper temperatures inside the beverage center.
•DO NOT block the toe grille on the lower front of your beverage center. Sufficient air circulation is essential for the proper operation of your beverage center.
•THIS BEVERAGE CENTER IS NOT INTENDED FOR OUTDOOR USE.
INSTALLATION
Installation Clearances
•Allow the following clearances for ease of installation, proper air circulation, and plumbing and electrical connections:
Sides & Top | 3/8” |
Back | 1” |
DOOR OPENING
NOTE
If your beverage center is placed with the door hinge side against a wall, you may have to allow additional space so the door can be opened wider.
Your beverage center should be positioned to allow easy access to a counter when removing food. To make this possible, the direction in which the doors open can be reversed. See Door Removal & Reversal Instructions.
LEVELING
All four corners of your beverage center must rest firmly on a solid floor. Your beverage center is equipped with adjustable leveling screws to help level your unit.
To Level Your
Beverage Center:
1.Remove toe grille.
2.Use adjustable wrench to adjust leveling screws.
NOTE
Raise the front of the beverage center enough so the doors close freely when opened halfway. The beverage center should slope ¼” to ½” from front to back. Then level the beverage center from side to side.
Raise
Stationary Front Roller
with Leveling Screw
CAUTION
DO NOT ATTEMPT TO MOVE OR RELOCATE THE BEVERAGE CENTER WITH A KEG INSIDE.
4
