Lens Assembly Installation/Replacement
The
LED PCB
2. Lens Screws
1.
2.
1. LED plastic UV cover
3. LENS Assembly
1.Remove the front, plastic UV cover (black) by removing the screws that hold it in place. There are 4 screws to remove for this step.
2.After removing the glass cover, remove the screws that hold the lens assembly in place. There are 5 screws for this step.
Note: use care when performing this procedure, as this gives you direct access to the LEDs, which are very fragile.
3.You now should have full access to the lens assembly. This must be removed and the old lenses must be replaced with the new lenses. The same assembly is to be reinstalled with the new lenses in place and the process is complete.
Warning! | 1. When replacing the lens assembly, please make sure that the power is |
| disconnected from the fixture beforehand. |
COLORdash™ Par User Manual | 10 | 9/4/2008 12:09 PM |