Setting Oven Controls
Setting the Clock
The CLOCK | pad is used to set the clock. The clock may be |
|
|
set for 12 or 24 hour time of day operation. The clock has been |
|
| |
preset at the factory for the 12 hour operation. When the range is |
|
| |
first plugged in, or when the power supply to the range has been |
|
| |
interrupted, the timer in the display will flash with power failure "PF" |
|
| |
(See Fig. 1). |
|
|
|
|
| Fig. 1 | |
|
|
| |
| INSTRUCTIONS | PRESS | DISPLAY |
To set the clock (example below for 1:30):
1. Press 
. "CLO" will appear in the display (Fig. 2).
2. Press | pads to set the time of day to 1:30 (Fig. 3). | Fig. 2 |
|
"CLO" will appear in the display. Press 
. "CLO" will disappear and the clock will start (Fig. 4).
Fig. 3
Changing between 12 or 24 hour time of day display:
1.Press and hold 
for 6 seconds (Fig. 3). While holding the pad down the current time of day will remain and "CLO" will disappear from the display (Fig. 4). CONTINUE holding the pad until a beep is heard.
2.The display will show either "12Hr"(Fig. 5) or "24Hr"(Fig. 6).
3.Press 
to switch between the 12 and 24 hour time of day display. The display will show either "12Hr" (Fig. 5) or "24Hr" (Fig. 6).
4.Press 
to accept the desired change or press 
to reject the change.
5.Reset the correct time as described in To set the Clock above. Please note that if the 24 hour time of day mode was chosen, the clock will now display time from 0:00 through 23:59 hours.
10
for 6 seconds
Fig. 4
Fig. 5
or 
Fig. 6
