Minolta PI4700E user manual Tip for, Output Setting

Setup tab 4

(4)Output Setting

This function selects the tray in the machine to which the paper is to be distributed. Settings can also be made for finishing functions including stapling, hole punching, and folding.

• Paper exit destination	Select the machine tray to which you wish to distribute
	the prints. The selectable paper exit trays are limited by
	the type of finisher installed in the machine.
	Mailbin Finisher
	Except Mailbin Finisher

•Mailbin paper exit desti- If Mailbin is selected as the paper exit destination, set

nation	the mailbin to which you wish to distribute the paper.
• Detail of Output Setting	Set stapling, punching or folding. For details, see
	page 4-13.

✎

Note for (1)

If you print a document that contains pages of different sizes and/or different directions in the same job, the image may be partially cut or images may overlap each other.

✎ Tip for (1)

The printing layout is displayed on the Page Layout. ✎

Notes for (2)

If you print a document that contains pages of different sizes and/or different directions in the same job, the image may be partially cut or images may overlap each other.

Two-sided printing and OHP interleaving cannot be set simultaneous- ly.

✎

Tips for (2)

The sizes for which you can perform two-sided printing are from 140 × 182 mm to 297 × 432 mm.

Short Edge Binding, Long Edge Biding, Booklet Left Binding and Booklet Right Binding are displayed on the Page Layout.

✎

Note for (3)

Some paper sizes cannot be selected. For details, refer to the User Manual of the machine.

Properties Settings Chapter 4

Pi4700e 4-9