Minolta PI4700E user manual Setting Up IP Parameters, Bundled Utility Programs, Other Methods

Setting Up IP Parameters 12

12.7Setting Up IP Parameters

Before you can use TCP/IP for network printing, you must first assign the following IP parameters to the Network Card: IP address, subnet mask, default gateway.

You can use any of the following methods for assigning IP parameters to the Network Card.

Bundled Utility Programs

Management Access Program (MAP) (Windows) or a Web browser See “8.7 Using the utility software”

Note that your computer must have IPX/SPX conversion protocol in- stalled in able to use MAP.

BOOTP (Windows)

See “8.7 Using the utility software”.

Other Methods

ARP command (Windows)

See “Assigning IP Addresses Using ARP (For Windows)”.

ARP command (UNIX)

See “Assigning IP Addresses Using ARP (For UNIX)”.

BOOTP daemon (UNIX)

See “Assigning IP Addresses Using the BOOTP Daemon (For UNIX)”.

RARP daemon (UNIX)

See “Assigning IP Addresses Using the RARP Daemon (For UNIX)”.

DHCP daemon (UNIX)

See “Using the DHCP Daemon (For UNIX)”.

Note

If you start up the Digital Copier with its initial factory default setup without assigning a Digital Copier IP address, ATIP (Automatic Tem- porary IP Address) automatically assigns an IP address and subnet mask. You can use IP address assigned by ATIP to detect the Digital Copier with the MAP utility. To change the current IP address and sub- net mask setting, first access the Digital Copier’s Web setup page from MAP, and then make the changes you want.

Appendix Chapter 12

Pi4700e 12-53