Minolta PI4700E user manual Setting Up the Protocol

8

Network Interface Card Chapter 8

Using the utility software

✎

Note

The above procedure is not registered in the error log when it is per- formed. Powering the Digital Copier down clears log contents.

Setting Up the Protocol

You can use the Protocol setup command to configure non-AppleTalk network protocols. On the Option menu, select Protocol setup to display the dialog box shown below.

You can use the radio buttons on the dialog box to enable and disable pro- tocols. We recommend that you select off for protocols that are not used on your network.

After enabling TCP/IP, you can set or change IP parameters. Input the val- ues for your network environment into the IP Address, Subnet Mask, and Default Gateway fields on the dialog box.

✎

Note

Check with your network administrator if you are not sure of the IP pa- rameter settings you should make for your network environment.

In some cases, the IP parameters all show zeros. This indicates that IP parameters are not set, it does not indicate the current IP parame- ters.

1After making the settings you want, click the OK button.

2To enable the new settings, power the Digital Copier down and then

back up again. You can then check the settings on the status page.

8-36 Pi4700e