Minolta PI4700E user manual AT&T/SVR4 SCO Unix System None of the above, Pi4700e 12-49

UNIX Configuration 12

SCO UNIX

The installation procedure for SCO UNIX is similar to that for HP-UX. The Network Card solution uses a network direct filter named nicfilter. The sys- tem invokes nicfilter directly from the printer interface file.

After performing the procedure under Loading the Program, you must configure the printer and make it known to the lp system.

1Type the following to run the installation script: nicinst

The script automatically downloads the appropriate Network Card util- ities for your system and displays questions to prompt you for the in- formation it needs.

2Select your system you are using from the list of options that appears and then press Enter .

1)AT&T/SVR4; 386

2)SCO UNIX System V

3)None of the above

3What is the node name of the Network Card?

Input the host name recorded in /etc/hosts and then press Enter . For example, type printfast.

4What is the printer name for this Network Card-linked printer? Type the printer name and press Enter .

5Here, the script displays the information you have input up to this point.

Node name of the Printer Server Card: printfast

Printer name to be used: <printer name>

The printer is attached on: PORT 1

Check these settings and make sure they are correct. If they are cor- rect, type yes and press Enter . Otherwise, type no and press Enter .

6Is this printer PostScript?

Type yes and press Enter	if the printer is a PostScript printer. Other-
wise type no and press	Enter	.

Appendix Chapter 12

Pi4700e 12-49