Minolta PI4700E Using Telnet to Make Settings, Establishing a Telnet Connection, Pi4700e 12-61

Using Telnet to Make Settings

12.8Using Telnet to Make Settings

12

In addition to the MAP and Web browser combination for making settings, this Network Card also supports use of Telnet for setting up the environ- ment. Network Card settings can be make from a Telnet client platform.

The following settings can be made over a Telnet connection.

IP parameter changes

LPD settings

Protocol changes

Unit reset

Factory setting restore

Password changes

Note

The Network Card must be assigned a valid IP address before you can use a Telnet connection to make settings. Also, the computer you are using for the Telnet connection must have TCP/IP enabled, and must be able to operate as a Telnet client. See “12.7 Setting Up IP Param- eters” (p. 12-53) for more information about assigning IP parameters to the Network Card.

Establishing a Telnet Connection

1Start up the Telnet client.

2Specify the IP address of the Network Card and connect.

3At the login: prompt, use one of the ID’s shown below to log in.

	ID	Password
To check settings:	guest	guest
To change settings:	sysadm	sysadm

4This displays the Main Menu shown below.

The Configuration Utility Unit Serial no. 460121 V5.04 Main Menu

1.IP Parameters

2.LPD Printers

3.Protocols

4.Reset Unit

5.Restore Factory Defaults

Appendix Chapter 12

Pi4700e 12-61