Minolta PI4700E user manual 11-4 Pi4700e

Troubleshooting Chapter 11

11 Unable to Print

Symptom	Possible Cause	Action
Unable to staple	No stapling can be effected if the	Check the type of paper.
properly.	type of paper is thick paper or
	OHP transparencies.
	When Mailbin Finisher or Multi-	Check the number of prints to be
	staple Finisher is installed, no	made.
	stapling can be effected if num-
	ber of prints to be made exceeds
	50.
	When Single-staple Finisher is
	installed, no stapling can be ef-
	fected if number of prints to be
	made exceeds 30.
	No stapling can be effected if the
	number of pages to be printed is
	50 or more when a Folding Fin-
	isher is mounted. Center Staple
	is also disabled if the number of
	pages to be printed is 15 or
	more.
	No stapling can be effected if
	original document contains pag-
	es of different sizes.
The stapling position	The paper direction and N-up do	Change the setting for Orienta-
is opposite to what is	not match the setting made for	tion.
expected.	Orientation.
Unable to specify	Either a Multi-staple Finisher,	Select “Multi-staple Finisher”
Punch.	Mailbin Finisher or Folding Fin-	“Mailbin Finisher” or “Folding
	isher must be mounted to enable	Finisher” from “Installable Op-
	the setting of Punch, and “Multi-	tions.”
	staple Finisher”, “Mailbin Finish-
	er” or “Folding Finisher” must be
	selected from “Installable Op-
	tions” to specify Punch.
	Punch cannot be specified if	Check the setting of Booklet and
	Booklet or OHP interleaving is	OHP Interleaving.
	specified.
Unable to effect	No holes can be made if the type	Check the type of paper.
Punch.	of paper is thick paper or OHP
	transparencies.
	Prints can at times be fed out	Check the direction of the paper.
	without being punched if the di-
	rection of the paper loaded in the
	paper source is not appropriate.
The hole punch posi-	The paper direction and N-up do	Change the setting for Orienta-
tion is opposite to	not match the setting made for	tion.
what is expected.	Orientation.

11-4 Pi4700e