Minolta PI4700E user manual Ping Network Card IP address, Quit Bootp

Using the utility software 8

✎

Note

Use colons to delimit each octet in the MAC address as shown on the Network Card’s status page.

5 Reset the Digital Copier by powering it down and then back up again.

The above step outputs a fixed-period BOOTP request.

6 Click the Go button on the BOOTP dialog.

7 Wait for about five minutes until the Network Card resets.

8 Select Verify from the Admin menu. You should get a response that in- dicates whether or not your unit is active.

❍ If you get a message stating that the unit is active, you should be able to ping to the Network Card using the steps below.

❍ If you get a message stating that the unit is not active, check whether TCP/IP is enabled on the status page.

9 Display the MS-DOS prompt and type the following:

ping <Network Card IP address>

10 Repeat step 8 until a response is received. Configuration is complete when a response starting with the words Reply from... is returned.

11 Quit BOOTP.

✎

Note

You cannot use BOOTP to assign an IP address if the Network Card has already been assigned an IP address by ATIP.

Network Interface Card Chapter 8

Pi4700e 8-33