Using Telnet to Make Settings

12

 

Restore Factory Defaults

Select this menu item to restore the Network Card to its initial factory de- faults. All of the parameters stored in NVRAM are restored to their initial factory defaults.

Note

Initial factory default values do not take effect until you finish the Telnet session or power the Network Card down and then power it up again.

Change Password

Select this menu item to change the password used for Telnet connection and access to the HTTP server. In response to the New Password prompt, type in up to eight characters for the new password and then press Enter . In response to the Retype New Password prompt, input the new password again for confirmation, and then press Enter .

Note

The password you specify here is used for both Telnet and Web page access. Changing the password using one type of access (Telnet or a Web browser) also changes the password for the other type of access.

Exiting Telnet (Exit)

Inputting E while at Main Menu after changing settings causes the menu shown below to appear.

The Configuration Utility

Unit Serial no. 460121 V5.04

Exit

1.Save Changes and Exit

2.Save Changes and Reset

3.Exit Without Saving Changes

Select 1 to save your changes without applying them.

Select 2 to save your changes and reset the Network Card, which applies the changes.

Select 3 to discard your changes.

Appendix Chapter 12

Pi4700e

12-63

Page 414
Image 414
Minolta PI4700E user manual Restore Factory Defaults, Change Password, Exiting Telnet Exit, Pi4700e 12-63