Minolta PI4700E user manual Network Card Reset Procedure

Jumper switch setting 8

NVRAM. Reset the Network Card before moving the printer to another en- vironment or any other time is becomes necessary to reconfigure it to suit another environment.

Network Card Reset Procedure

1Power down the Digital Copier and unplug it from its power outlet.

2Disconnect the network cable from the Network Card.

3Remove the Network Card from the printer by performing the steps in Setup Instructions in reverse.

4Locate the reset jumper switch (labeled OP2) on the Network Card. See the illustration under “Network Card and Jumper Pin Positions”.

5Change the OP2 jumper switch to its FACT position (OP2 set to pins 1 and 2).

6Use the procedures in Setup Instructions to re-install the Network Card. Do not connect the network cable to the Digital Copier at this time.

7Plug in the Digital Copier and power it up.

The Network Card performs a self-test, indicated by the green LED flashing three times, following by the green LED and amber LED flash- ing alternately. After the green and amber LEDs start to flash, power down the Digital Copier and unplug it from its power outlet.

8Remove the Network Card from the Digital Copier again.

9Return the OP2 jumper switch to pins 2 and 3.

10Use the procedures in Setup Instructions to re-install the Network Card.

Network Interface Card Chapter 8

Pi4700e 8-51