Minolta PI4700E user manual Configuration Procedure Windows NT, Installing the printer Windows NT

Peer-to-Peer Printing with TCP/IP 3

Configuration Procedure (Windows NT 4.0)

1Install TCP/IP under Windows NT 4.0.

Refer to the applicable Windows documentation for more information.

2Assign the IP parameters.

See “3.2 Specifying the IP Address From the Printer’s Touch Panel” (p. 3-2) for more information.

3Install the IP Peer-to-Peer Printing Program.

Use the IP Peer-to-Peer Printing Program for peer-to-peer printing. See “3.4 Peer-to-Peer Printing Program (Windows)” (p. 3-8) for more information.

4Use the procedure below to install the printer.

Installing the printer (Windows NT 4.0)

1On the Start menu, point to Settings and then click Printers.

2Double-click Add Printer and install the printer. Make the new printer the default printer.

See “2 Installing the Printer Driver” (p. 2-1) for details about how to in- stall it.

3Right-click the new printer icon and select Properties from the menu.

4Display the Ports tab.

5From the Print to the following port(s) list, select the port where the Digital Copier IP address is displayed.

6Click the OK button of the Properties dialog box to close it.

7Right-click the printer icon again to display its Properties dialog box, display the General tab, and then perform a Test Print operation.

8If the test prints normally, complete the procedure by clicking OK to close the Properties dialog box.

After you finish installing a printer with the above procedure, you can use it just as you would any standard local printer. The printer can also be used as a network printer by other Windows computers on your network whose Windows NT 4.0 systems are configured the same way as de- scribed above.

Network Settings Chapter 3

Pi4700e 3-7