Minolta PI4700E AS/400, Internet address must be the Network Card IP address, Pi4700e 12-35

UNIX Configuration 12

5Type the appropriate Network Card values on the window that ap- pears.

The following table shows some sample settings.

Item	Example	Input Data Description
Printer Name	myprinter	Name used in the lp command
Remote System Name	fastprint	Network Card host name recorded in /etc/
		hosts
Remote printer Name	PORT1	lpd queue name (You can use any name you
		want here.)

6From the three settings at the bottom of the window, select Remote Printer is on BSD System.

7Click OK.

8Ping the Network Card to check the connection. ping <Network Card IP address>

When ping causes the message shown below to return, it means the IP address is setup correctly.

<Network Card IP address> is alive.

AS/400

When working with the output queue description (WORKOUTQD), you must provide information for a number of fields in order to allow the Net- work Card to function properly as a remote printer device.

1When prompted for the remote system, type INTNETADR so the AS/ 400 system recognizes the device as an IP device.

2Input an appropriate name (like PORT1) for the remote printer queue name.

3Connection type must be IP.

4Internet address must be the Network Card IP address.

5Destination Type must be OTHER.

6In response to the message asking if you want to convert SCS to ASCII, type YES.

This tells the AS/400 system to convert text.

7For Manufacturer type and model, specify the printer driver that comes with the printer controller.

Appendix Chapter 12

Pi4700e 12-35