Minolta PI4700E user manual Jumper switch setting, Network Card and Jumper Pin Positions

Network Interface Card Chapter 8

8 Jumper switch setting

8.9Jumper switch setting

This chapter explains how to change the settings of the Network Card’s jumper switch settings.

Normally, the Network Card automatically makes network configuration settings, so you do not need to change jumper switch settings. There may be certain situations, however, where it becomes necessary to change jumper switch settings.

Important!

Special care is required when handling the Network Card.

The Network Card is designed to protect components from electrostat- ic discharge during normal operation. Be sure to take proper electro- static protection measures whenever handling the Network Card.

Be sure to unplug the Digital Copier from its power outlet before starting work. For full details on handing the Network Card, see the Setup Instruc- tions that comes with the Network Card.

Network Card and Jumper Pin Positions

The illustration below shows the positions of the jumper switches on the Network Card.

* Default pin positions are indicated in gray.

Resetting to Factory Defaults

Jumper switch OP2 can be used to reset all Network Card parameters to their initial factory default settings. The function of OP2 is to reconfigure

8-50 Pi4700e