Setting the Clock
Clock
The ,o,o_pad is used to set the clock. The clock may be set for 12 or 24 hour time of day
operation. The clock has been preset at thefactory for the 12 hour operation. When the
range is first plugged in, or when the power supply tothe range has been interrupted, the
timer in the display will flash along with "PF" (power failure, See Figure 1).
When PF appears in the display and 12:00 is flashing, press _ _
_,_i_,,•No sound will be heard,
but after 10 seconds a beep will sound and PF will disappear.

INSTRUCTIONS PRESS

To set the clock (example below for 1:30)

Press .o,_o_."CLO" will appear in the display (Figure 2). Clock
Horl,_ge
2. Press 130pads to set the time of day to 1:30 (Figure
3). "CLO" will stay in the display. Press 6_ART• CLO will
disappear and the clock will start (Figure 4).

Changing between 12 or 24 hour time of day display

1. Press and hold ,_,_o'_for 7 seconds (Figure 3). After 7 seconds,
"12Hr" (Figure 5) or "24Hr" (Figure 6) will appear inthe display
and the control will beep once.
2. Press _I[_, to switch between the 12 and 24 hour time of day
display. The display will show either "12Hr" (Figure 5) or "24Hr"
(Figure6).
3. Press toaccept the change or press _%_,'_fto reject the
change.
4. Reset the correct time as described in To set the Clock above.
Please note that if the 24 hour time of day mode was chosen,
the clock will now display time from 0:00 through 23:59 hours.
13 0
c!,_ for 7 seconds
Clean
Nettewr
or
Figure 1
DISPLAY
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6