CARE & CLEANING

Cleaning the cooktop and surface burners (cont’d)

To clean the surface burner heads

For proper gas flow it may be necessary to clean the burner ports. Before cleaning be sure the gas burners are turned off. First use a clean DAMP cloth to soak up any spills. Remove any food from the burner ports using a small nonabrasive brush like a toothbrush and afterwards wipe up using a damp cloth. For stubborn soils located in the burner ports, use a small gauge wire or needle to clean.

Any spill on or around the electrode must be carefully cleaned. Take care not to hit the electrode with any thing hard or it could be damaged.

Removing and replacing surface burners To remove burners

1.Remove shipping screws with a Phillips Head screwdriver. See Fig. 1 for screw locations.

2.Tilt the burner at the end closest to the support bar until the locator tab is released (front burners tilt right, rear burners tilt left). Move the burner towards the back of the range. This will separate it from the gas valve at the front of the range.

To replace burners

1.Slide the burner tube over the gas valve at the front of the range (front burners fit over the right valve, rear burners fit over the left valve on each side of the range).

2.Tilt burner so that the locating tab will slide into the slot on the support bar. Make sure burners are properly seated on support bar and are level.

3.Replace shipping screws.

rear burners

shipping screws

locating

tab

locating tab

front burners

burner

support bar

gas

valves

Fig. 1

Replacing oven light (some models)

CAUTION

Be sure the range is unplugged and all parts are COOL before replacing oven light. Wear a leather-faced glove for protection against possible broken glass.

The interior oven light bulb is located at the upper left rear of the oven cavity.

To replace the oven light bulb

1.Turn electrical power off at the main source or unplug the range.

2.Replace bulb with a new 40 watt appliance bulb.

3.Turn power back on again at the main source (or plug the appliance back in).

4.The clock will then need to be reset. To reset, see “Setting the clock” in this Use & Care Guide.

16

Page 16
Image 16
Frigidaire FFGF3011LW Replacing oven light some models, Removing and replacing surface burners To remove burners