Setting surface controls
Always select cookware that is suitable for the amount and type of food being prepared. Set a flame size appropriate to the pan. Adjust burner to a setting that does not allow flames to extend beyond the outer edge of the cooking utensil.
When a surface control knob is turned to the LITE position, the selected surface burner will ignite automatically from a spark generated by the electric ignitor.
Setting surface burners
1.Place cooking utensil on center of surface burner grate. Make sure the utensil is centered and stable on the grate.
2.Push the desired surface control knob in and turn counterclockwise out of the OFF position (Fig. 1).
3.Release the knob and rotate to the LITE position. Visually check that the gas burner has lit.
4.Push the control knob in and turn counterclockwise to the desired flame size. Use the control knob markings and adjust the flame as needed.
CAUTION
Do not place flammable items such as plastic salt and pepper shakers, spoon holders or plastic wrappings on the cooktop when it is in use. These items could melt or ignite. Potholders, towels or wooden spoons could catch fire if placed too close to the range cooktop.
NOTES
DO NOT cook with the surface control knob in the LITE position. The electronic ignitor will continue to spark if the control knob is left in the LITE position.
When setting any surface control knob to the LITE position, all electronic surface ignitors will spark at the same time. However, only the surface burner you are setting will ignite.
SETTING SURFACE CONTROLS
Fig. 1
IMPORTANT
•NEVER place or straddle a cooking utensil over 2 different surface cooking areas at the same time.
•Do not place aluminum foil, or ANY material that can melt on the range cooktop. If these items melt they may permanently damage the cooktop surface.
•In the event of an electrical power outage, the surface burners can be lit manually. Use caution when lighting surface burners manually. To light a surface burner, hold a lit match to the burner head, then slowly turn the surface control knob to LITE. After burner lights push in and turn knob to desired setting.
Home Canning
Be sure to read and observe all the following points when home canning with your appliance. Check with the USDA (United States Department of Agriculture) website and be sure to read all the information they have available as well as follow their recommendations for home canning procedures.
•Use only quality flat bottom canners when home canning. Use a
•Use only a completely flat bottom canner with no ridges that radiate from the bottom center when home canning using a ceramic cooktop.
•Make sure the diameter of the canner does not exceed 1 inch beyond the surface element markings or burner. It is recommended to use smaller diameter canners on electric coil and ceramic glass cooktops.
•Start with hot tap water to bring water to boil more quickly.
•Use the highest heat seating when first bringing the water to a boil. Once boiling is achieved, reduce heat to lowest possible setting to maintain that boil.
9
