Pioneer DEH-P6000UB Switching Auto PI Seek, Setting the rear output and subwoofer controller

	Section
Initial Settings	04

Switching Auto PI Seek

The unit can automatically search for a differ- ent station with the same programming, even during preset recall.

1Use MULTI-CONTROL to select AUTO PI.

2Press MULTI-CONTROL to turn Auto PI

seek on.

# To turn Auto PI seek off, press MULTI-CONTROL again.

when the car’s headlights are turned on. You can turn the dimmer on or off.

1Use MULTI-CONTROL to select DIMMER.

2Press MULTI-CONTROL to turn dimmer

on.

# To turn dimmer off, press MULTI-CONTROL again.

Setting the rear output and subwoofer controller

English

Switching the warning tone

If the front panel is not detached from the head unit within four seconds of turning off the ignition, a warning tone sounds. You can turn off the warning tone.

1Use MULTI-CONTROL to select

WARNING TONE.

2Press MULTI-CONTROL to turn warning

tone on.

# To turn warning tone off, press MULTI-CONTROL again.

Switching the auxiliary setting

Auxiliary devices connected to this unit can be activated individually. Set each AUX source to ON when using. For more information about connecting or using auxiliary devices, refer to Using the AUX source on page 34.

1Use MULTI-CONTROL to select AUX1/ AUX2.

2Press MULTI-CONTROL to turn AUX1/

AUX2 on.

# To turn AUX off, press MULTI-CONTROL again.

Switching the dimmer setting

To prevent the display from being too bright at night, the display is automatically dimmed

This unit’s rear output (rear speaker leads out- put and RCA rear output) can be used for full- range speaker (REAR SP :FULL/

PREOUT:REAR) or subwoofer

(REAR SP :SUB W/PREOUT:SUB W) connec- tion. If you switch the rear output setting to REAR SP :SUB W, you can connect a rear speaker lead directly to a subwoofer without using an auxiliary amp.

Initially, the unit is set for rear full-range speak- er connection (REAR SP :FULL). When rear output is connected to full range speakers (when REAR SP :FULL is selected), you can connect the RCA subwoofer output to a sub- woofer. In this case, you can select whether to use the subwoofer controller’s (low pass filter, phase) built-in PREOUT:SUB W or the auxili- ary PREOUT:REAR.

1Use MULTI-CONTROL to select

SW CONTROL.

2Press MULTI-CONTROL to display the

setting mode.

# Press BACK to return to the previous display.

3Press MULTI-CONTROL to select the seg- ment you wish to set.

Press MULTI-CONTROL repeatedly to switch the segment in the following order:

REAR SP (rear speaker setting)—PREOUT (RCA output setting)

4Use MULTI-CONTROL to select the de- sired setting.

Turn to change the setting.

En 31