Oven vent location

The oven vent is located at center rear of cooktop below the control panel (See Fig. 1). When the oven is on, warm air passes through this vent. This venting is necessary for proper air circulation in the oven and good baking results. Do not block the oven vent.

oven vent location

BEFORE SETTING OVEN CONTROLS

Removing, replacing & arranging racks

To remove - pull the rack forward until it stops. Lift up front of rack and slide out.

To replace - fit the rack onto the guides on the oven walls. Tilt the front of the rack upward and slide the rack back into place.

Arranging - always arrange the oven racks when the oven is cool (prior to operating the oven).

CAUTION

Always use oven mitts when using the oven. When using the appliance, oven racks and cooktop will become very hot which can cause burns.

Fig. 1

Types of oven racks

flat handle oven rack

flat

oven rack

offset oven rack

The flat oven rack or flat handle oven rack (some models) may be used for most cooking needs.

The offset oven rack (some models) is designed to place the base of the rack about 1/2 of a rack position lower than normal. This rack design provides several additional possible positions between the standard positions.

Fig. 2

Recommended rack positions by food type

Food type

Position

 

(Fig. 2)

 

 

Broiling meats

See broil

Cookies, cakes, pies, biscuits & muffins

2 or 3

Frozen pies, angel food cake, yeast, bread

 

and casseroles

1 or 2

Small cuts of meat or poultry

1 or 2

Turkey, roast or ham

1

Air circulation in the oven

For best baking results allow 2-4" (5-10 cm) around the cookware for proper air circulation and be sure pans and cookware do not touch each other, the oven door, sides or back of the oven cavity. Hot air must be able to circulate around the pans and cookware in the oven for even heat to reach around the food.

7

Page 7
Image 7
Frigidaire FFGF3011LB, FFGF3011LW important safety instructions Before Setting Oven Controls