6.2.2 Filtration Problems
Problem | Probable Causes | |
| A. Power cord is not plugged in or | |
| circuit breaker is tripped. | |
|
| |
| B. Pump motor has overheated | |
| causing the thermal overload | |
Filter pump won't | switch to trip. | |
| ||
start. |
| |
|
| |
| C. Blockage in filter pump. | |
| Test: Close the drain valve and | |
| pull the filter pan out from the | |
| fryer. Activate the pump. If the | |
| pump motor hums for a short time | |
| then stops, the probable cause is | |
| blockage of the pump itself. | |
Filter pump runs | Blockage in filter pan suction tube. | |
Test: Close the drain valve and pull | ||
but oil does not | ||
return to frypot and the filter pan out from the fryer. | ||
there is no bubbling Activate the pump. If bubbling oil | ||
oil. occurs, there is a blockage in the | ||
| filter pan suction tube. | |
Filter pump runs, | A. Improperly installed filter pan | |
but oil return is very | ||
components. | ||
slow and bubbling | ||
| ||
oil occurs. |
|
B.Attempting to filter with oil that is not hot enough.
6.2.3Error Messages
See chapter 2 in the controller manual.
Corrective Action
A. Verify that the power cord is fully plugged in. If so, verify that circuit breaker is not tripped.
B. If the motor is too hot to touch for more than a few seconds, the thermal overload switch has probably tripped. Allow the motor to cool at least 45 minutes then press the Pump Reset Switch.
C. Pump blockages are usually caused by sediment buildup in the pump due to improperly sized or installed filter paper and failure to use the crumb screen. Call a FAS.
The blockage may be caused by sediment buildup or, if solid shortening is used, solidified shortening in the tube. Use a thin, flexible wire to remove the blockage. If the blockage cannot be removed, call a FAS.
A. If using filter paper or pad configuration, verify that filter screen is in bottom of pan with paper or pad on top of screen.
Verify that
If using Magnasol filter assembly, verify that
B. See filter section on page
