Frymaster 45 Series manual Pin 6?

1.10.2 Troubleshooting the 24 VAC Circuit in Units with Interface Boards

Verify that the drain

valve is fully closed, then

turn the controller on.

Which LEDs are lit?

GV LED (with

None24V LED onlyor without other LEDs)

Is 24VAC
present on IFB 24V					Yes
terminals?
	No
Probable cause
is a failed 24-volt
transformer.
Probable cause						Is 24VAC
is a failed interface		No				present on J1
board.						Pin 6?
							Yes
Attempt to light pilot. If
the pilot will not light, see
			No			Is pilot lit?
Troubleshooting the Gas
Valve on Page 1-33.
							Yes
If unit has a drain safety switch,						Is 24VAC
probable cause is open or failed
switch. If not, probable cause is loose				No		present on Pin 20 of 20-pin
or missing jumper between Pins 10						terminal block?
and 19 of 20-pin terminal block.
							Yes
Probable cause is failed
						Is 24VAC			Problem is with gas valve.
wiring between 20-pin
			No			present at the gas		Yes	See Troubleshooting the
terminal block and gas
						valve?			Gas Valve on Page 1-33.
valve.

1-30