Frymaster E4 operation manual Problem, Fryer repeatedly

Problem Probable Causes

Fryer repeatedly

cycles on and off Fryer is in melt-cycle mode. when first started.

Fryer does not heat	Drain valve is open.
after filtering.
Fryer heats until	Temperature probe or controller has
high limit trips with
	failed.
heat indicator ON.

Corrective Action

This is normal for fryers equipped with CM III.5 computers, Basket

Lift Timers, and Digital Controllers. The default operational mode for these controllers is for the elements to cycle on and off until the temperature in the frypot reaches 180ºF (82ºC). In CM III.5 computers, CYCL will appear in the display when in the melt-cycle mode. The purpose of the melt- cycle is to allow controlled melting of solid shortening to prevent scorching and flash fires or damage to the element. If you are not using solid shortening, the melt-cycle can be cancelled or bypassed. Refer to the separate Frymaster Fryer Controllers User's Manual for the procedure for canceling the melt- cycle for the particular controller installed on your fryer.

In fryers equipped with Solid State (Analog) controllers, the melt- cycle is controlled manually by means of the rocker switch to the right of the temperature control knob. If not using solid shortening, press the rocker switch to the OFF position to turn off the melt-cycle.

This fryer is equipped with a drain safety switch that prevents the heating element from being energized if the drain valve is not fully closed. Verify that the drain valve is fully closed.

Turn fryer off and call FASC.

6-3