Frymaster MPF50S Series manual Replace Heater Strip, MPF50S SERIES PORTABLE FILTRATION SYSTEMS

MPF50S SERIES PORTABLE FILTRATION SYSTEMS

CHAPTER 6: TROUBLESHOOTING/SERVICE PROCEDURES

6.4.2 Replace Heater Strip

1.Disconnect power cord from power supply.

2.Perform Step 2, Section 6.4.3.1, Replace Motor.

3.Remove screws securing outer panels and cord-holding bracket. Remove bracket and the panels.

Remove screws securing outer panels.

4.Turn the unit on its side and remove four nuts securing the filter pan to the base assembly. Carefully pull the filter pan away from the base to gain access to heater strip. Use care not to damage the flexlines connecting the pan to the pump.

Remove four nuts securing filter pan to base (arrows).

5.Remove foil-insulating tape securing the heater strip to the pickup tube. Remove the heater strip from the pickup tube.

6.Remove the remainder of the foil-insulating tape from the flexline(s) and the pump, and then remove the heater strip. Note routing of the heater strip on the pump and flexline(s) prior to heater strip removal.

Remove foil-insulating tape to expose heater strip (arrow).

6-5