DC IN 3V socket
1
1514
!
Take care not to drop the batteries when opening
and closing the battery cover.
!
See P.97 for notes on using other power supplies.
Install the batteries with the correct polarity as
shown.
Close the battery cover.

SELECTING THE POWER SUPPLY

The special AC Power Adapter AC-3V can be
used to avoid power loss during photography,
playback or image downloading (using the USB
connection) due to depleted batteries.
Check that the camera is switched off and then
plug the AC power adapter connector into the
DC IN 3V socket on the camera. Then plug the
AC power adapter into the power outlet.
!
You cannot charge the batteries by connecting the
AC power adapter.
!
The socket-outlet shall installed near the equipment
and shall be easily accessible.
!
The shapes of the plug and socket-outlet depends
on the country of use.
!
Using AC power adapters other than the AC-3V
could damage the camera.
!
See P.99 for more information on the AC power adapter.
LOADING THE SmartMediaTM
SmartMediaTM
Only use 3.3V SmartMedia.
<For Camera>
MG-4S (4MB), MG-8S (8MB), MG-16S (16MB),
MG-32S (32MB), MG-64S (64MB)
<For Audio> SmartMedia with ID
MG-16SW (16MB), MG-32SW (32MB), MG-64SW
(64MB)
!
Images cannot be recorded or erased if a write-
protect sticker is affixed to the SmartMedia.
!
Operation of this camera is only guaranteed when it
is used with Fujifilm SmartMedia.
!
Some 3.3V SmartMedia are labelled as 3V
cards.
!
SmartMedia with ID are labelled as ID
cards.
!
See P.100 for more information on SmartMedia.
Check that the camera is turned off. Then turn
the camera so that the battery cover is
upwards and slide the cover open.
Push the SmartMedia firmly into the SmartMedia
slot as far as it will go.
Close the battery cover.
!
If you open the battery cover while the camera is
switched on, the camera is automatically switched
off to protect the SmartMedia.
!
The SmartMedia will not slide fully into the slot if it is
inserted facing the wrong way. Be careful not to
apply undue force to the SmartMedia.
4
A SmartMedia with ID is needed to use the
audio function.
Using the AC Power Adapter (sold separately)