FujiFilm A200 manual SET-UP gPOWER Save, HPower saving on default setting, HPower saving OFF

SET–UP gPOWER SAVE

ＳＥＴ－ＵＰ

ＩＭＡＧＥ ＤＩＳＰＬＡＹ ＯＦＦ ＰＯＷＥＲ ＳＡＶＥ ＯＮ

ＵＳＢ ＭＯＤＥ ＤＳＣ ＤＡＴＥ／ＴＩＭＥ ＳＥＴ

ＯＫ ＢＡＣＫ

hPower saving “ON” (default setting)

Power consumption is kept to a minimum to prevent battery depletion. You should select the “ON” setting when you are using alkaline batteries.

iIf the camera is not used for approximately 30 seconds, the LCD switches off temporarily to reduce power consumption (Sleep mode).

iOnce the camera is in Sleep mode, if it is left unused for a further 90 seconds, it is automatically switched off.

iThe charging time for the flash increases slightly because the flash charging power is reduced.

hPower saving “OFF”

Batteries are more likely to run flat since no power reduction measures (sleep mode, etc.) are used. However, this function automatically switches the camera off if the camera is not

66used for approximately 2 minutes.

To bring the camera out of sleep mode so that it is ready to shoot, press “d”, “c”, “a” or “b”. This is useful since the camera is ready to shoot more quickly than when it is switched off and then on again. You can also take pictures when the camera is in sleep mode simply by pressing the shutter button.

●! Power Save/Auto Power Off does not function when a USB connection is being used.

●! You can also bring the camera out of sleep mode by pressing buttons other than “d”, “c”, “a” or “b”.

●! To switch the camera back on, briefly switch the camera off and then on again.

The Sleep function does not operate when the LCD monitor is switched off, while you are setting the quality mode or when the camera is in SET–UP or Playback mode. However, if the camera controls are not used for 2 minutes, the camera automatically switches off.