Fujitsu 2300 manual Using Hotpads, Programmable hotpad, Volume hotpads, Speaker Mute hotpad

Note that power to several system components must be restored before system operation resumes. Allow sufficient time for system operation to resume before attempting to use the system. If your system uses Suspend-to-Disk mode, it will take longer to resume operation as compared to using Suspend-to-RAM mode. Time is needed to read data from the hard disk drive.

• Use the system as you normally would once system operation resumes.

All programs resume at the point where execution stopped when system operation was suspended.

Using Hotpads

Hotpads are pen-active areas below the system display that you can use to change the display and speaker settings while the system is running. To use a hotpad, tap directly on it with the pen. You can also press and hold the pen tip against the Volume, Contrast, and Brightness hotpads to automatically repeat the hotpad function. The location of each hotpad is shown in Figure 2-1.

Programmable	Speaker	Display
	Mute	Select

Volume Volume

Down Up

	Fast Slow	Slow Fast	Down		Up
	Down	Up
	Contrast (certain systems			Brightness
do not have contrast hotpads)

Figure 2-1 Hotpads

A summary of each hotpad’s function is given below:

•Programmable hotpad

This hotpad can be programmed for application-specific functions. Contact your local help desk or reseller if you need assistance using the Programmable hotpad.

•Volume hotpads

These hotpads set the volume of the pen tablet speaker or headphones, if used. (Note that the internal speaker is disabled when headphones are plugged in.)

•Speaker Mute hotpad

This hotpad turns the pen tablet speaker or headphones on or off. When you tap this hotpad to turn on the speaker or headphones, the system beeps.

Using Hotpads 2-7