SWING OPERATION
Begin air conditioner operation before performing this procedure.
To select SWING Operation
Press the SWING button (Fig. 6 b11).
The SWING Display (Fig. 7 c8) will light.
Each time the SWING button is pressed, the swing operation will change in the following order.
Up/down swing operation Left/right swing operation
Swing operation stops Up/down/left/right swing operation
To stop SWING Operation
Press the SWING button and select STOP.
Airflow direction will return to the setting before swing was begun.
About Swing Operation
●Up/down swing: Swing operation begins using the following range according to the current airflow direc- tion.
Airflow direction is
With the upper
Airflow direction is
With the
●Left/right swing: The
●Up/down/left/right swing: The
●The SWING operation may stop temporarily when the air conditioner’s fan is not operating, or when operating at very low speeds.
●If the SET button(Vertical) is pressed during the up/ down swing operation, the up/down swing operation will stop and if the SET button(Horizontal) is pressed during the left/right swing operation, the left/right swing operation will stop.
COIL DRY OPERATION
The Indoor unit can be dried by pressing the COIL DRY button on the Remote Control Unit so as to avoid going moldy and restrain the breed of bacterium.
The COIL DRY Operation will operate for 90 minutes after pressing the COIL DRY button and it will stop automatically.
To select COIL DRY Operation
Press the COIL DRY button (Fig. 6 b4) during operation or when it stops.
The COIL DRY Indicator lamp (yellow) will light.(Then OPERATION Indicator lamp doesn’t light.)
The COIL DRY Display (Fig. 7 c4) will light. Then it will disappear after 10 seconds.
To cancel COIL DRY Operation
Press the START/STOP button (Fig. 6 b8) during COIL DRY
Operation.
When the COIL DRY Display
Light up: Press the START/STOP button once
Light off: Press the START/STOP button twice.
The COIL DRY Indicator lamp (yellow) (Fig.3 a7) will go out.
Then the operation stops.
About COIL DRY Operation
●Press the COIL DRY button again during COIL DRY Operation, COIL DRY Opera- tion can be reset.
●The COIL DRY Operation cannot get rid of the existed mould or bacterium, and it has no sterilization effect either.