Fujitsu Heat & Cool Model (Reverse Cycle) manual Cleaning And Care, En-13, Cleaning the Air Filter

Models: AOU12RLS Heat & Cool Model (Reverse Cycle) ASU12RLS AOU9RLS ASU9RLS

1 20
Download 20 pages 3.22 Kb
Page 14
Image 14
CLEANING AND CARE

CLEANING AND CARE

CAUTION!

Before cleaning the indoor unit, be sure to turn it off.

● Be sure the Open Panel (Fig. 4 a9) is installed securely.

● When removing or replacing the air filters, be sure not to touch the heat exchanger, as personal injury may result.

Cleaning the Open Panel

1.Remove the Open Panel.

1Place your fingers at both lower ends of the grille panel, and lift forward; if the grille seems to catch partway through its movement, continue lifting up- ward to remove.

2Pull past the intermediate catch and open the Open Panel wide so that it become horizontal.

Open Panel

Mounting

shaft

Knob

Cleaning the Air Filter

1. Open the Open Panel, and remove the air filter.

Lift up the air filter’s handle, disconnect the two lower tabs, and pull out.

Air filter (Right & Left)

Air filter handle

Hooks(two places)

2. Remove dust with a vacuum cleaner or by washing.

After washing, allow to dry thoroughly in a shaded place.

3.Replace the Air Filter and close the Open Panel.

1Align the sides of the air filter with the panel, and push in fully, making sure the two lower tabs are returned properly to their holes in the panel.

2. Clean with water.

Remove dust with a vacuum cleaner; wipe the indoor unit with warm water, then dry with a clean, soft cloth.

3. Replace the Open Panel.

1Pull the knobs all the way.

2Hold the grille horizontal and set the left and right mounting shafts into the bearings at the top of the panel.

3Press the place where the arrow on the diagram indi- cates and close the Open Panel.

Mounting

shaft

BearingCleaning the Open Panel

Knob

2 Close the Open Panel.

Hooks(two places)

 

(In the above figure, the open panel is omitted for the expla- nation.)

Dust can be cleaned from the air filter either with a vacuum cleaner, or by washing the filter in a solution of neutral detergent and warm water. If you wash the filter, be sure to allow it to dry thoroughly in a shady place before rein- stalling.

If dust is allowed to accumulate on the air filter, airflow will be reduced, lowering operating efficiency and increas- ing noise.

During periods of normal use, the Air Filters should be cleaned every two weeks.

Don't operate the air conditioner with being opened the open panel.

When used for extended periods, the indoor unit may accumulate dust inside, reducing its performance. We recommend that the indoor unit be inspected regularly, in addition to your own cleaning and care. For more information, consult authorized service personnel.

When cleaning the indoor unit’s body, do not use water hotter than 104 °F, harsh abrasive cleansers, or volatile agents like benzene or thinner.

Do not expose the indoor unit’s body to liquid insecticides or hairsprays.

When shutting down the indoor unit for one month or more, first allow the fan mode to operate continuously for about one-half day to allow internal parts to dry thoroughly.

En-13

Page 14
Image 14
Fujitsu Heat & Cool Model (Reverse Cycle) manual Cleaning And Care, En-13, Cleaning the Open Panel 1.Remove the Open Panel