PREPARATION
Load Batteries (AAA/R03/LR03 ⋅ 2)
1 | Press and slide the battery compartment lid on the re- | ||||
verse side to open it. |
|
|
|
| |
| Slide in the direction of the arrow while pressing the mark. | ||||
2 | Insert batteries. |
|
|
|
|
Be sure to align the battery polarities ( | ) correctly. | ||||
3 | Close the battery compartment lid. | ||||
Set the Current time |
|
|
|
| |
1 | Press the CLOCK ADJUST button (Fig. 6 b14). | ||||
Use the tip of a | |||||
2 | Use the TIMER SET ( | / |
|
| ) buttons (Fig. 6 b13) to |
|
| ||||
adjust the clock to the current time. | |||||
button: Press to advance the time. 
button: Press to reverse the time.
| (Each time the buttons are pressed, the time will be advanced/reversed in |
| |
| quickly in |
3 | Press the CLOCK ADJUST button (Fig. 6 b14) again. |
This completes the time setting and starts the clock. |
To Use the Remote Control Unit
●The Remote Control Unit must be pointed at signal receiver (Fig. 3 a8) to operate correctly.
●Operating Range: About 23ft (7 meters).
●When a signal is properly received by the air conditioner, a beeping sound will be heard.
●If no beep is heard, press the Remote Control Unit button again.
Remote Control Unit Holder
Insert | Slide up | |
Press in | Pull out | |
Screws | ||
| ||
1 Mount the Holder. 2 Set the Remote Control | 3 To remove the Remote | |
Unit. | Control Unit (when use at | |
| hand). |
CAUTION!
●Take care to prevent infants from accidentally swallowing batteries.
●When not using the Remote Control Unit for an extended period, remove the batteries to avoid possible leakage and damage to the unit.
●If leaking battery fluid comes in contact with your skin, eyes, or mouth, immedi- ately wash with copious amounts of water, and consult your physician.
●Dead batteries should be removed immediately and disposed of properly, either in a battery collection receptacle or to the appropriate authority.
●Do not attempt to recharge dry batteries.
Never mix new and used batteries, or batteries of different types.
Batteries should last about one year under normal use. If the Remote Con- trol Unit’s operating range becomes ap- preciably reduced, replace the batteries and press the RESET button with the tip of a ballpoint pen or other small object.
