CLEANING THE PLASMA AIR CLEANING FILTER
WARNING!
CAUTION!
Before cleaning the plasma filter unit, be sure to turn off the power supply to the air conditioner. Electric shock may result.
●Make sure the plasma filter unit is properly mounted before cleaning or performing other tasks on it. If the unit is not properly mounted, it could fall off and cause damage or injury.
●You can be injured if you touch the heat exchanger when removing or installing the plasma filter unit. Do not insert your fingers between the plasma filter unit and the heat exchanger.
Regarding the Air Cleaning check function
●This function is illustrated by the flashing of the AIR CLEAN indicator lamp (green), indicating that the unit requires maintenance.
After Air Cleaning Mode has been in use for approximately 400 hours, the AIR CLEAN indicator lamp (green) will begin to slowly flash (approximately once every 7 seconds). When this occurs, the unit requires maintenance.
After Air Cleaning Mode has been in use for approximately 500 hours, the AIR CLEAN indicator lamp (green) will begin to flash quickly (approximately once every 3 seconds). At this point, Air Cleaning will cease functioning. Please carry out appropriate maintenance for the unit.
●Please carry out unit maintenance every 6 months.
●If a squeaking or chirping sound is heard, unit maintenance needs to be carried out, even if the AIR CLEAN indicator lamp (green) is not flashing.
Cleaning the dust collection unit
1. Open the intake grille and remove the air | 2. Remove the dust collection unit. |
filter on the right. |
|
● Please consult the instructions for cleaning the air filter on page 12.
handle
3.Wash with water and dry.
1 Soak the plasma filter unit in warm water (104 to 122 °F) for 10 to 15 minutes. If the plasma filter unit is extremely dirty, extremely dilute a mild synthetic laun- dry detergent (low alkalinity or isotope detergent) to 15 times the standard concentration and allow the
plasma filter unit to soak in it.
2Gently move up and down and to the right and left. A soft sponge can also be used to wipe the surface.
3Rinse with clean water.
4Shake the plasma filter unit to drain off the water. (If the plasma filter unit is extremely dirty, repeat Steps 1 through 4 two or three more times.)
5Place the plasma filter unit in the shade and allow it to dry completely.
Securely grasp the dust collection unit by the handle and pull it out (as shown by the arrow).
(The above figure is only for reference, so the intake grille is not included).
●Only use a mild synthetic laundry detergent (low alkalinity or isotope detergent).
●Never disassemble the plasma filter unit.
●Never soak the plasma filter unit in hot water.
●Never wipe the plasma filter unit with a scrub brush or other hard or abrasive items. This will damage the honey comb filter.
●Never insert a brush into the inside of plasma filter unit for washing. This will damage the internal parts and cause malfunctioning of the plasma filter unit.
●Never use dryer or other device to blow hot air on the plasma filter unit. This will cause deformation or other damage.
●Before
