Fujitsu CG-311 SERIES instruction manual AC Power Connection, Input

POWER CONNECTION

This camera uses 24VAC or 12VDC power sup- ply for the main supply.

CAUTION:

Take care not to short-circuit the power line wire, when connecting the power-supply cord to the camera.

A. AC POWER CONNECTION

PAL: A main supply of 24VAC (21.6 to 26.4 VAC) 50Hz is required.

NTSC: A main supply of 24VAC (21.6 to 26.4 VAC) 60Hz is required.

This main supply must also have a minimum

CAUTION:

Confirm that the cord is connected to the terminal securely by pulling the cord. Confirm that there is no whisker of wires

outside the holes of terminal.

Connect to 24VAC class 2 power supply only. Make sure to connect the grounding lead to the GND terminal when the power is supplied from a 24VAC power source.

CAUTION:

When two or more cameras are used by one transformer, use a transformer having the rated current more than the current

consumed with the number of cameras ⋅ 24VAC 270 mA.

TRANSFORMER

rating of 270mA.

Remove the sheath at the end of power cord in the length of 10mm.

Twist and straighten the wires, then insert the wires to three holes of the terminal.

INPUT

OUTPUT

REAR PANEL

Button

If the insertion can not be made smoothly, try it again while pushing respective button above the hole.

En-10

AC 24 V

Fig.5