Fujitsu E600 - page 20

Proceed as follows to prepare the PC for the vertical operating position:

1. If you have already operated the PC, switch it off and disconnect all cables from the casing.

2. Assemble the base feet in the direction of the arrow.

3. Place the casing on the right side so that the On/Off switch is at the bottom.

4. Fit the base feet with the screws included (1) (one screw per foot and hole).

5. Place the unit on the base feet and reconnect any cables disconnected previously.

CHAPTER 1(01-12) 6/5/03, 7:54 PM4

Contents

Main i DESKPOWER E600 Series Users Manual ii IMPORTANT SAFETY INSTRUCTIONS iii iv Before reading this manual v vi vii Conventions Used in This Manual CAUTION viii Important Notes Safety CAUTION Manufacturers notes Energy saving ix FCC Class B Compliance Statement NOTE: x Transporting the PC CAUTION Cleaning the PC xi xii Warning and caution labels Inside the PC main unit Rear of the PC main unit ATTENTION WARNING Organization of This Manual xiv Contents CHAPTER 1 Preparing for Use Preparing for Use.............................................................................. 2 CHAPTER 2 Operation CHAPTER 3 Troubleshooting and Tips xv CHAPTER 4 System Expansion System Expansion.......................................................................... 26 CHAPTER 5 Technical Data Technical Data.................................................................................46 Page Page Preparing for Use Unpacking and Checking the Delivery Steps for Initial Setup Setting Up the PC Page Connect the Monitor, Mouse and Keyboard Connecting the monitor Connecting the mouse Connecting the keyboard Connecting the PC to the Mains Voltage Initial Switch-on: Software will be Installed Switching on monitor and PC 0I Installing the software Connecting External Devices LAN Page Page Page Operation Switching On the PC Switching Off the PC Indicators On the PC Page 17 WARNING Settings in BIOS Setup Property and Data Protection Unlocking and Locking Casing Anti-theft Protection and Lead-sealing BIOS Setup Security Functions Page Troubleshooting and Tips Installing New Software Power-on Indicator Remains Unlit after you have Switched on your Device The screen stays blank No Mouse Pointer Displayed on the Screen The Floppy Disk Cannot be Read or Written Time and/or Date is not Correct Error Messages on the Screen Restoring the Hard Disk Contents Tips Page Page System Expansion Information about Boards Opening the Casing Closing the Casing a Installing and Removing a Board Page Page Page Page Low-Profile Boards Mounting slot adapter Removing slot adapter Installing and Removing the Graphics Card Installing the graphics card Removing the graphics card Installing and Removing Drives Replacing Drive in 51/2 inch Bay Page Folding Up and Down the Drive Cage Changing the Floppy Disk Drive Replacing a Hard Disk Drive Page Page Replacing Lithium Battery Page Electrical Data Technical Data