Opening the Casing | Fujitsu E600 specs

■Opening the Casing

Switch the PC off. The PC must not be in the energy-saving mode!

CAUTION

Please take note of the safety information in the "Important notes" chapter. Pull the power plug out of the mains outlet!

Remove all cables from the casing.

Place the casing in a convenient working position.

Turn the key upward if necessary to unlock the casing.

Press the two locking catches (1), hold them pressed and slide the upper casing in the direction of the arrow (2) until the spacing (a) is approximately 2 cm.

Lift off the top cover in an upward direction (3).

a

27

Image 43

Fujitsu E600 user manual Opening the Casing

Contents

Deskpower E600 Series User’s Manual Important Safety Instructions Iii For Safe Operation Before reading this manual Backing Up the Data Using this Product for High-Safety Applications Microsoft Service Pack Introduction Conventions Used in This ManualNotational conventions Energy saving SafetyImportant Notes Manufacturer’s notes FCC Class B Compliance Statement Transporting the PC Cleaning the PCCleaning the system unit and the monitor Cleaning the keyboard and the mouse Reference to products Disposal and recycling Xii Before Reading This Manual Organization of This Manual Contents System Expansion Technical Data Xvi Chapter External devices Steps for Initial SetupPreparing for Use Unpacking and Checking the Delivery Vertical operating position Setting Up the PCPage Connecting standard keyboard Connecting the monitorConnect the Monitor, Mouse and Keyboard Connecting USB mouse Connecting the mouseConnecting the keyboard Connecting a PS/2 mouse Connecting the PC to the Mains Voltage Switching on monitor and PC Initial Switch-on Software will be Installed Disconnecting cables Connecting External DevicesInstalling the software Connecting cables Ports on the PC LAN Settings of the parallel port Connecting external devices to the serial portConnecting external devices to the parallel port Settings of the serial port Connecting external devices to the USB ports Operation Switching Off the PC Switching On the PCOperation SmartCard reader indicator Indicators On the PCCD-ROM indicator Floppy disk indicator Hard disk indicator Power-on indicator Locking the casing Settings in Bios SetupProperty and Data Protection Unlocking and Locking Casing Anti-theft Protection and Lead-sealing Bios Setup Security Functions Troubleshooting Tips Internal power supply overloaded Troubleshooting and TipsInstalling New Software Mains voltage supply is faulty Screen stays blank Wrong RAM modules have been inserted No Mouse Pointer Displayed on the ScreenFloppy Disk Cannot be Read or Written Wrong monitor has been set under Window XP Tips Error Messages on the ScreenRestoring the Hard Disk Contents Time and/or Date is not CorrectPage System Expansion Information about Boards System Expansion Opening the Casing Closing the Casing Installing board bracket Installing and Removing a BoardRemoving board bracket Make the required settings for the board Installing a boardPage Removing a board Page Mounting slot adapter Low-Profile BoardsRemoving slot adapter Installing the graphics card Installing and Removing the Graphics Card Removing the graphics card Replacing Drive in 51/2 inch Bay Installing and Removing DrivesIDE drives and serial ATA drives Close the casing see Closing the casing chapter Folding Up and Down the Drive Cage Changing the Floppy Disk Drive Replacing a Hard Disk Drive Page Page Replacing Lithium Battery Technical Data Electrical Data Technical Data