42
Installing a hard disk drive
1 Take the new hard disk drive out of its packaging.
2 Make the required settings on the drive if necessary (e.g. Master/Slave/CableSelect
with IDE drives).
3 Secure the EasyChange rails on the side of the hard disk by inserting the upper pins of
the EasyChange rail in the corresponding holes of the hard disk.
3 Press the EasyChange rails in the direction of the arrows (1).
4 Pull the hard disk drive out of the carrier (2).
5 Pull the EasyChange rails off the hard disk drive.
CHAPTER 4(37-44) 6/5/03, 7:59 PM42