Serial Port, Port Replicator Connector, Infrared Port

1.Align the connector with the port opening.

2.Push the connector into the port until it is seated.(Figure 4-14)

3.Tighten the two hold-down screws, located on each side of the connector.

Figure 4-14. Connecting a Parallel Device

SERIAL PORT

The serial port, or COM port, located on the system and on the optional Port Replicator allows you to connect serial devices, such as printers or scanners. In order to connect a serial interface device follow these easy steps:

1.Open the plastic cover that is over the port, then align the connector with the port opening.

2.Push the connector into the port until it is seated (Figure 4-15).

3.Tighten the two hold-down screws, located on each side of the connector.

Figure 4-15. Connecting a Serial Device

PORT REPLICATOR CONNECTOR

The port replicator connector is used for the connection of your notebook to an optional port replicator. In order to connect your notebook to this device, follow the instructions that came with your port replicator. (See Figure 2-7 on page 11 for location)

UNIVERSAL SERIAL BUS PORTS

The Universal Serial Bus 2.0 ports (USB) allow you to connect USB devices such as external game pads, pointing devices, keyboards and/or speakers. There are four USB 2.0 ports on your notebook: one on the left side and three on the right.

In order to connect a USB device follow these steps:

1.Align the connector with the port opening.(Figure 4- 16)

2.Push the connector into the port until it is seated.

U s e r I n s t a l l a b l e F e a t u r e s

Due to the ongoing changes in USB tech- nology and standards, not all USB devices and/or drivers are guaranteed to work.

Figure 4-16. Connecting a USB Device

INFRARED PORT

The Infrared IrDA (4Mbps) port allows for wireless data transfer between your notebook and other IrDA- compatible devices, such as another computer or a printer, without the use of a cable. The infrared port is located adjacent to the wireless LAN switch (See Figure 2-3 on page 6 for location)

It is important to keep in mind that while carrying out this form of communication, both devices must be placed so their infrared ports are directly facing each other without obstruction. The devices must also be separated by at least 6" but no more than 36" for maximum performance.

The following conditions may interfere with infrared communications:

■A television, radio remote control unit, or a wireless headphone is being used nearby.

■Direct sunlight, fluorescent light, or incandescent light shines directly on the port.

■Do not move either device while com- munication is active as it may interrupt data transmission.

■Be careful not to scratch the infrared port lens. Dirt, scratches, or other sur- face marks can degrade operation.

HEADPHONE JACK

The headphone jack allows you to connect headphones or powered external speakers to your notebook. Your headphones or speakers must be equipped with a 1/8” (3.5 mm) stereo mini-plug. In order to connect head- phones or speakers follow these easy steps: