Fujitsu E8310 manual Re-install your device. See Device Ports on page, for more information

L i f e B o o k E 8 0 0 0 N o t e b o o k

Problem	Possible Cause	Possible Solutions
You have installed an	Your external device is not	Re-install your device. (See Device Ports on page 46
external keyboard or	properly installed.	for more information)
mouse, and it does not
	Your operating system soft-	Check your device and operating system docu-
seem to work.
	ware is not set up with correct	mentation and activate the proper driver.
	software driver for that device.
You have connected an	Your operating system soft-	Check your device and operating system
external keyboard or a	ware is not setup with correct	documentation and activate the proper driver.
mouse and it seems to be	software driver for that device.
locking up the system.
	Your system has crashed.	Try to restart your notebook.
Memory Problems
Your Power On screen does	Your memory upgrade module	Remove and re-install your memory upgrade
not show the correct	is not properly installed.	module. (See Memory Upgrade Module on page 44
amount of installed		for more information)
memory.
	You have a memory failure.	Check for Power On Self Test (POST) messages.
		(See Power On Self Test Messages on page 59 for more
		information)
Modem Problems
Messages about modem	Messages about modem	See your application software documentation for
operation.	operation are generated by	additional information.
	whichever modem application
	is in use.
Parallel, Serial, and USB Device Problems
You have installed a parallel	The device is not properly	Remove and re-install the device. (See Device Ports
port device, a serial port	installed.	on page 46 for more information)
device or a USB device.
	The device may have been	Close the application and restart your notebook.
Your LifeBook notebook
	installed while an application
does not recognize the
	was running, so your notebook
device, or the device does
	is not aware of its installation.
not seem to work properly.
	Your device may not have the	See your software documentation and activate the
	correct software driver active.	correct driver.
	You may have the wrong I/O	See your device documentation and software docu-
	address selected for your	mentation to determine the required I/O address.
	device.	Change the settings in the BIOS setup utility. (See
		BIOS Setup Utility on page 29 for more information)
	Your device and another device	Check all I/O addresses located within the BIOS
	are assigned the same I/O	setup utility and any other installed hardware or
	address.	software to make sure there are no duplications.
	Parallel port is set to output	Check parallel port setting in the BIOS and set to
	only.	bi-directional or ECP.
PC Card/ExpressCard Problems
A card inserted in the PC	The card is not properly	Remove and re-install the card. (See PC Cards/
Card or ExpressCard slot	installed.	ExpressCards™ on page 42 for more information)
does not work or is locking
up the system.

54