Fujitsu E8310 manual page 27 for more information, Panel on page 12 for more information

L i f e B o o k E 8 0 0 0 N o t e b o o k

Problem	Possible Cause	Possible Solutions
Your LifeBook notebook	You are operating on battery	Install a power adapter and then push the Power/
turns off all by itself.	power and ignored a low batt-	Suspend/Resume button. (See Power Sources on
(continued)	ery alarm until the batteries are	page 27 for more information)
	at the dead battery state and
	the system has gone into Dead
	Battery Suspend mode.
	You have a battery failure.	Verify the condition of the batteries using the
		Status Indicator panel, and replace or remove
		any batteries that are shorted. (See Status Indicator
		Panel on page 12 for more information)
	Your power adapter has failed	Make sure the adapter is plugged in and the outlet
	or lost its power source.	has power.
Your LifeBook notebook	The installed batteries	Replace the battery with a charged one or install
will not work on battery	are dead.	a power adapter.
alone.
	No batteries are installed.	Install a charged battery.
	The batteries are improperly	Verify that the batteries are properly connected
	installed.	by re-installing them.
	Your installed batteries	Verify the condition of the batteries using the Status
	are faulty.	Indicator panel and replace or remove any batteries
		that are shorted. (See Status Indicator Panel on
		page 12 for more information)
The batteries seem to	You are running an application	Use both the primary battery and an optional
discharge too quickly.	that uses a lot of power due to	second battery and/or use a power adapter for this
	frequent hard drive access or	application when at all possible.
	optical drive access, or use of a
	modem, LAN PC card, Wire-
	less LAN, or Bluetooth device.
	The power savings features	Check the Power Options menu settings and adjust
	may be disabled.	according to your operating needs.
	The brightness is turned all	Turn down the brightness adjustment. The higher
	the way up.	the brightness the more power your display uses.
	The batteries are very old.	Replace the batteries.
	The batteries have been	Replace the batteries.
	exposed to high temperatures.
	The batteries are too hot	Restore the notebook to normal operating tempera-
	or too cold.	ture. Charging icon on the Status Indicator panel
		will flash when battery is outside of operating range.
Shutdown and Startup Problems
The Suspend/Resume	Suspend/Resume button is	In Windows XP, enable the button by going to the
button does not work.	disabled.	Control Panel -> Power Options Properties and
		clicking on the Advanced tab. In the Power buttons
		area, select the option that best suits your needs. In
		Windows Vista, select the Change what the power
		button does” option.
	There may be a conflict with	Close all applications and try the button again.
	the software.

56