2. Installation
2.1. Installing the Imprinter
Install the Imprinter as follows:
1.Turn off the Scanner power and disconnect the power cable.
2.Remove the Stacker from the scanner.
Raise the Stacker upright as shown below while placing your fingers under the arms. Push the left arm gently towards the outside until you can release it towards you. Then do the same with the right arm to remove the Stacker completely.
c | d |
Raise the Stacker up as shown below.
ATTENTION● You must remove the stacker before installing the Imprinter with the Scanner.
●Do not use force, since this might damage the Stacker.
3.Install the Scanner onto the Imprinter.
Fix Tab
Hold the Scanner above the Imprinter rear. Gently place the Scanner onto the Imprinter base while lowering and pushing it forward until it touches the Imprinter.
ATTENTION● Be careful not to put the Scanner on the Fix Tabs or hitting it hard against them. You may damage the Fix Tabs.
●Be careful not to pinch your finger.
After installation
4.Insert the screws of the Fix Tabs to the rear of the scanner and tighten them to secure the Imprinter with the Scanner. (2 places)
5.Connect the Imprinter cable (EXT Cable) to the connector on the rear of the Scanner.
ATTENTION | The Imprinter will not work if the EXT cable is not |
| connected to the Scanner. Scanning when the EXT |
| cable is not connected can cause documents to |
| jam inside the Imprinter. |
6.Install the Stacker removed in procedure 2 above to the Imprinter.
First, hook one of the arms.
Then engage the other arm by pushing it gently.