3.When the scanner is automatically detected, [Found New Hardware Wizard] or [Add/Remove Hardware Wizard] dialog box appears. Click the [Cancel] button to close the Wizard dialog box.

4.Insert the "Setup CD-ROM" into the CD drive.

⇒<SETUP DISK START UP SCREEN> appears.

ATTENTION

This screen may not appear if the "AutoPlay" setting is set to off. In this case, find "Install.exe" in the CD-ROM using "Explore" or "My Computer" and execute it.

5.Click [INSTALL PRODUCTS], and then click [ISIS Driver].

6.Error Recovery Guide Installation dialog box appears.

Error Recovery Guide is an application with which you can view on-screen information for troubleshooting errors that may occur in the scanner. This guide helps solve problems, so select [Yes] to install it. You may

also choose to install it later.

ATTENTION

After you select [Yes] for installing Error Recovery Guide, the [Choose Setup Language] dialog box appears. Select a language and follow the on-screen instructions. The Error Recovery Guide dialog box is automatically displayed when the installation is complete. Wait until the installation of the ISIS driver starts.

7.Select a language for the installation on the [Choose Setup Language] dialog box, and then click the [Next] button.

8.Install the driver, following the on-screen instructions.

9.When you see the [InstallShield Wiizard Complete] dialog box, click the [Finish] button.

Your computer will restart and detect the scanner. Do not remove the Setup CD-ROM from the CD drive until your

computer completely starts up again.

ATTENTION

Depending on the operating system you are using, you may need to do the following.

Windows 2000:

If you see the [Digital Signature not Found] dialog box, click [Yes].

Windows Vista:

If you see the [Found New Hardware] dialog box, select [Locate and install driver software], and then in the [User Account Control] dialog box, click the [Continue] button, if it is displayed.

The installation of FUJITSU ISIS is complete. Next, install ScandAll PRO (D page 7).

ATTENTION

To make sure that FUJITSU ISIS is successfully installed, perform a scan with a ISIS-compliant application such as ScandAll PRO. For information about how to scan with ScandAll PRO, refer to section "2.4 Checking Scanner Driver Operation" on page 9.

ScandAll PRO

■Installing ScandAll PRO

ScandAll PRO is software for scanning images, which is in compliance with both TWAN/ISIS standards. Using FUJITSU TWAIN 32 or FUJITSU ISIS together with ScandAll PRO allows you to create document images.

ATTENTION

Be sure to log on as a user with "Administrator" privileges.

1.Insert the Setup CD-ROM into the CD drive.

⇒<SETUP DISK START UP SCREEN> appears.

2.Click [INSTALL PRODUCTS], and then click [ScandAll PRO].

7