■Connecting with the USB Cable
1.Connect the USB cable to the USB connector.
2.Connect the other end of the USB cable to the PC.
ATTENTION
•Be sure to use the USB cable which comes as an accessory with this scanner.
Scanning operation with commercially available cables is not guaranteed.
•When connecting to an USB hub, use the first stage USB hub that is closest to the computer. If you use the second or later hub stages, the scanner may not operate correctly.
•If you connect the scanner with USB 2.0, it is required that the USB port and Hub are compliant with USB 2.0. The scanning speed may slow down if it is connected with USB1.1.
■Connecting with the SCSI Cable
When using the scanner with a SCSI interface, the following SCSI cable and SCSI card must be purchased.
•SCSI cable:
Use a cable which complies with a 50 Pin Contact Shielded
•SCSI card:
Find the recommended SCSI card information in the Fujitsu web site (FAQ).
http://imagescanner.fujitsu.com/ATTENTION
•After connecting the SCSI cable, turn the scanner on.
•In a SCSI daisy chain formation, connect the scanner so that it is the terminated device.
1.Insert the SCSI cable into the SCSI connector of the scanner until both sides click.
2.Connect the other end of the cable to your computer.
ATTENTION
Be careful not to bend the pins of the SCSI connector when connecting to the scanner.
HINT
The SCSI ID initially set at the factory is [5]. If the SCSI ID of another SCSI device is set to the same ID, either change the scanner's SCSI ID or SCSI ID of the other SCSI device. For details on how to change the SCSI ID, refer to "Setting the SCSI ID" in this section (D page 4).
■Setting the SCSI ID
The factory initial setting for SCSI ID is [5].
1.Press the Power button at least for two seconds to turn off the scanner.
2.Set the SCSI ID using the SCSI ID switch on the back of the scanner.
|
| 4 | 5 | 6 |
|
| 3 |
| 7 |
| Click | 2 |
| 8 |
|
|
| ||
| 1 | 0 | 9 | |
|
| |||
|
|
|
| |
| ID No. |
|
|
| Description |
0 to 7 | Can be set as the ID | |||
8, 9 | Works with the factory default value | |||
| (SCSI ID = 5). | |||
3.Press the Power button to turn on the scanner.
When the scanner is turned ON, the SCSI ID set at Step 2 is enabled.
| 4 | |
|